Car stalls when i hit the gas after it starts, bad afm or map sensor?
#51
im still working in this thing, more work testing tommorow.
Haven't had much progress yet, I believe my throttle set plate is too low idk.
It will rev smoothly and sound great, but upon hitting.the gas it.will.drop to.the correct rpm say 800 rpm..it'll stay there for a few seconds then the rpms will drop and it will struggle to continue running.
I set the tps and.I don't want.to tighten the throttle cable.to bring.up.the idle (don't think that's ideal)
I didn't put rtv on my bac valve so I did that and ill be going over the voltages again tommorow.
Really like satch said I feel like I should just put.some miles on the car, , everything is all good other than the cold.start idle.
Other than that I have to put in my walbro 255, I have a rewire kit to use for it but should I use.it or put.it on later? I'm going to wire it for.continuous 12v , ill check how much voltage I'm getting on the stock pump before I.decide.
also put in a inner wheel well my driver side was missing, like.why would someone remove that? smh
Rotary > Pistons
Haven't had much progress yet, I believe my throttle set plate is too low idk.
It will rev smoothly and sound great, but upon hitting.the gas it.will.drop to.the correct rpm say 800 rpm..it'll stay there for a few seconds then the rpms will drop and it will struggle to continue running.
I set the tps and.I don't want.to tighten the throttle cable.to bring.up.the idle (don't think that's ideal)
I didn't put rtv on my bac valve so I did that and ill be going over the voltages again tommorow.
Really like satch said I feel like I should just put.some miles on the car, , everything is all good other than the cold.start idle.
Other than that I have to put in my walbro 255, I have a rewire kit to use for it but should I use.it or put.it on later? I'm going to wire it for.continuous 12v , ill check how much voltage I'm getting on the stock pump before I.decide.
also put in a inner wheel well my driver side was missing, like.why would someone remove that? smh
Rotary > Pistons
#59
Winter Rotary
iTrader: (5)
I'm sure the keg itself is great.. a reputable builder did it.. but when so much ignorance is bolted on and sitting behind the wheel , that's when I begin to worry. You know what your real problem is ? Its already been said... drive it. There is a thing called a break in period, and until that's achieved I wouldn't worry so much about some of this
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM