im still working in this thing, more work testing tommorow.

Haven't had much progress yet, I believe my throttle set plate is too low idk.

It will rev smoothly and sound great, but upon hitting.the gas it.will.drop to.the correct rpm say 800 rpm..it'll stay there for a few seconds then the rpms will drop and it will struggle to continue running.

I set the tps and.I don't want.to tighten the throttle cable.to bring.up.the idle (don't think that's ideal)


I didn't put rtv on my bac valve so I did that and ill be going over the voltages again tommorow.

Really like satch said I feel like I should just put.some miles on the car, , everything is all good other than the cold.start idle.

Other than that I have to put in my walbro 255, I have a rewire kit to use for it but should I use.it or put.it on later? I'm going to wire it for.continuous 12v , ill check how much voltage I'm getting on the stock pump before I.decide.

also put in a inner wheel well my driver side was missing, like.why would someone remove that? smh

Rotary > Pistons

 

This just made my head hurt

 

Sorry, using my smartphone and I'm not the best at typing with it

Rotary > Pistons

 

You do not listen very well.

 

dude you're just jealous of my car

Rotary > Pistons

 

My car runs and drives, broski, so no.

 

I think OP is secretly James Joyce's ghost aspiring to be a rotary mechanic.

 

You said it gets 12 MPG and its pretty much a completely stock na.

My car isn't registered or insured, so I have no reason to drive it...I assure you it'd likely have no problem driving it.

Rotary > Pistons

 

I'm sure the keg itself is great.. a reputable builder did it.. but when so much ignorance is bolted on and sitting behind the wheel , that's when I begin to worry. You know what your real problem is ? Its already been said... drive it. There is a thing called a break in period, and until that's achieved I wouldn't worry so much about some of this

 

And yes , my car gets 12mpg. . Difference here is that I *know* what the problems causing that are.

 

Yet u haven't fixed them.. lol

http://m.youtube.com/#/watch?v=kbYY5y2ySyE
Rotary > Pistons

 

Yup , that's what happens when you've got continuing medical expenses up to your eyeballs and want to also continue your hobby.

 

I told you I have spare parts and could get an ecu but I'm not a charity

Rotary > Pistons

 

It appears there have been a sufficient amount of barbs traded already related to this matter. If it is to continue then it needs to be taken to a private conversation via pm's as this thread nor any other thread is not the place for this type of behavior.

 

Too right you are, Satch.

 

fixed the beep all it was is my power steering computer because I removed my power steering stuff in the bay

Rotary > Pistons