breakin into the 13s
Thread Starter
Junior Member
Joined: Mar 2003
Posts: 29
Likes: 0
From: texas
breakin into the 13s
what would it take to break a s4 t2 into the 13s...i was wondering if the following mods could do the job
full rb exhaust,720 secondaries,fcd,afc,boost controller,walbro fuel pump, rising rate fpr,intake,and TID mod
thanks
full rb exhaust,720 secondaries,fcd,afc,boost controller,walbro fuel pump, rising rate fpr,intake,and TID mod
thanks
it wont take much, when i first got my TII going with mazda reman motor, all i had was full exhaust (no cat) with 3in down pipe and intake, boost was at 8-10. i had no fcd but for some reason i did not get fuel cut off maybe cause my cars missing boost pressure sensor. i was pulling high 13's, but clutch was slipping.
so basicly for a thousand and change (cad) i was in the 13's
so basicly for a thousand and change (cad) i was in the 13's
I made only run because of tranny problems. The pass was made with BAD heat soak from the 2 hour freeway drive, I just paid, and hopd right into teh staging lanes. I was running 10psi. I still have my NA catback
60ft-2.181
594ft-8.651
1/8 et-9.184
1/8 mph-84.38
1/4 et-13.851
1/4 mph-102.55
60ft-2.181
594ft-8.651
1/8 et-9.184
1/8 mph-84.38
1/4 et-13.851
1/4 mph-102.55
Thread
Thread Starter
Forum
Replies
Last Post
Rotary12Ahead
1st Generation Specific (1979-1985)
9
Oct 29, 2015 03:16 PM
Syonyk
General Rotary Tech Support
4
Aug 23, 2004 02:58 AM



