88 convertible N/A limp mode
Thread Starter
Can Post Only in New Member Section
Joined: May 2018
Posts: 3
Likes: 0
From: zuni, va
88 convertible N/A limp mode
So i have been researching this for a while now and cant seem to find the answer i need. I have an 88 13b N/A that is in limp mode well at least showing the signs. I just replaced my OMP and lines and then put it back together, ending with the same results. so i have a few questions. first: since the OMP is mechanical, what is telling the ECM to go into limp mode? Second: how do i eliminate this all together and just premix? Thanks ahead of time.
Rotary Freak
Joined: Nov 2001
Posts: 1,520
Likes: 231
From: Alexandria, VA
You haven't mentioned any error codes. Have you pulled the error codes yet? Here's a link that might help you: FC3S Pro v2.0:  How-To - Zenki FC3S Error Codes
Thread Starter
Can Post Only in New Member Section
Joined: May 2018
Posts: 3
Likes: 0
From: zuni, va
Also i found a little green wire between the alternator plug and the ACV plugs that was not connected and for the life of me cant find where it belongs. any help would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
P'cola FD
3rd Generation Specific (1993-2002)
3
May 6, 2002 08:39 AM
Mindphrame
3rd Generation Specific (1993-2002)
5
Apr 4, 2002 07:40 AM
AquaMonster
General Rotary Tech Support
4
Nov 30, 2001 08:51 PM