What 20b "#" do you have?
#351
20b GTX4294R MS Dry-Sump
iTrader: (27)
AutoEXE produced a very small number of 20b's with:
Built from ALL BRAND NEW PARTS
Brand New C and D code spec 4mm thicker dowel pin land side plates
Brand New OEM mazda E-shaft
Brand New LIM, UIM,TB, ELbow
Brand NEW Twins
Brand NEW FD3S Rotor housings (Built in Japan after 20B rotor housing NLA)
Brand New Staygears
Brand New rotors
Brand New oil pan and pick up tube
ETC... ETC.. ETC..
Plus all the Autoexe upgrades internally
Better than a C or D code..
Email from AutoEXE discussing their upgrades internally I found out that they do Port the motor slightly, but were originally designed to make more bottom end.
"Do you mean fine tuning ports(big port) about Rotor housings?
Yes,we did it for just for street level(not too bigger).
Best regards,
Shingo Soma
AutoExe inc."
Built from ALL BRAND NEW PARTS
Brand New C and D code spec 4mm thicker dowel pin land side plates
Brand New OEM mazda E-shaft
Brand New LIM, UIM,TB, ELbow
Brand NEW Twins
Brand NEW FD3S Rotor housings (Built in Japan after 20B rotor housing NLA)
Brand New Staygears
Brand New rotors
Brand New oil pan and pick up tube
ETC... ETC.. ETC..
Plus all the Autoexe upgrades internally
Better than a C or D code..
Email from AutoEXE discussing their upgrades internally I found out that they do Port the motor slightly, but were originally designed to make more bottom end.
"Do you mean fine tuning ports(big port) about Rotor housings?
Yes,we did it for just for street level(not too bigger).
Best regards,
Shingo Soma
AutoExe inc."
#363
Junior Member
Join Date: Jan 2008
Location: Sussex, UK
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
I've had B913 sitting on a stand in my garage for 2 years now.
It has low compression on one rotor, I think one of the seals may be carbon locked as it sometime tests ok.
I must get around to doing something with it.
It has low compression on one rotor, I think one of the seals may be carbon locked as it sometime tests ok.
I must get around to doing something with it.
#367
Full Member
Join Date: Dec 2012
Location: South Jersey
Posts: 59
Likes: 0
Received 0 Likes
on
0 Posts
Hi, new to the fourms here don't mean to ressurect an old thread but does anyone know where to buy a C or D series 20b now adays? I've looked all over. They seem very rare
Thanks,
Jared
Thanks,
Jared
#370
Can Post Only in New Member Section
Join Date: Jan 2013
Location: NZ
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
i have A031 well did have all of it swaped the housings out for pp 13b and irons out for fc apart from thick iron , still have the original plates under the bench tho
#371
AponOUT!?
iTrader: (31)
Just picked up D449 last night! The company selling it had (6) 20Bs for sale, yes SIX MOTORS. As of 1/24/13 they still have one A-series and one C-Series left. Here's their contact info: http://www.facebook.com/DragInternational they are located in Davie, FL (just outside of Ft. Lauderdale).