Will these FD rotorhousings fit my 12A motor ???
#52
Can't Hear Now
iTrader: (62)
Crit, he's right. Those aren't GSL-SE housings. Those are newer housings with water seal grooves cut into them. There is a threaded boss for a knock sensor above the trailing plug holes in the housings in the pictures. Also you can see the "bumps" on the top where the tension bolts pass through. You don't see those on SE housings and also look at the air holes below the exhaust ports.
#54
Lives on the Forum
iTrader: (5)
I like the idea, especially if the groove could be cut in the ground 13b housings. The housings always flake and de0chrome on the edge, so this is pretty cool. I guess once the 12a housing stockpile is totally gone this may become much more common. And, as mentioned earlier, you already have ported exhaust.
#55
OBEY YOUR MAZDA
Thread Starter
Continue here.
New organized thread with proper title
https://www.rx7club.com/1st-generation-specific-1979-1985-18/my-12a-blowthrough-build-up-725724/
New organized thread with proper title
https://www.rx7club.com/1st-generation-specific-1979-1985-18/my-12a-blowthrough-build-up-725724/
Thread
Thread Starter
Forum
Replies
Last Post