Oil injectors, OMP
#1
Full Member
Thread Starter
Oil injectors, OMP
Hi
I have a rx7 with 12a bridgeport, and at the moment I have i main doubt, I will put a new manifold with a Weber IDA 48, and the doubt is: what the oil injectors that I have to put in there? the stock location is on stock carb... Please, I need help with this.
This is a street car, and I don't want run only premix!
regards
I have a rx7 with 12a bridgeport, and at the moment I have i main doubt, I will put a new manifold with a Weber IDA 48, and the doubt is: what the oil injectors that I have to put in there? the stock location is on stock carb... Please, I need help with this.
This is a street car, and I don't want run only premix!
regards
Trending Topics
#8
RX for fun
iTrader: (13)
Im too **** when it comes to this things. if you have a micrometer, measure the outside diameter of the ffiting. you will notice that one end is bigger than the other. find a drill bit that is the same size as the smaller end. after drilling the holes, slide the brass fitting (inside of the fuel bowl and out) with the smaller end facing out. this is to ensure that the fitting doesnt come out. then shorten each end to your liking and be sure that the fitting doesnt interfere with the float
sorry for long explanation but once you're doing it, you will understand where I'm coming from.
sorry for long explanation but once you're doing it, you will understand where I'm coming from.
Thread
Thread Starter
Forum
Replies
Last Post