got my whole setup ready!!, what you think?
02-27-08, 09:41 PM
#28
ROTor HEAD
Join Date: Apr 2007
Location: Omaha, NE
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
Crap Crap Crap.. sorry, had a red cherry header problem and totally forgot. Ill get the measurments also... Will take a lil bit.. not to long, just called my buddy and hes bringing over his camera.
The only other thing I can think of for jetting is your accelerator pump screws. Did you make sure that the small opening in them lined up with the small opening on the carb? The jets themselves have notches so they are lined up... But if you don't line up the flat head screw right, your gonna have a carb that is very hesitant.
Ill be back...
The only other thing I can think of for jetting is your accelerator pump screws. Did you make sure that the small opening in them lined up with the small opening on the carb? The jets themselves have notches so they are lined up... But if you don't line up the flat head screw right, your gonna have a carb that is very hesitant.
Ill be back...
02-27-08, 10:19 PM
#29
ROTor HEAD
Join Date: Apr 2007
Location: Omaha, NE
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
I wrote down alot of measurments.... lol.. This should be what you need I think, if not I have other measurments... Ignore the the mess, haven't put everything back to where it needs to be 
Thread
Thread Starter
Forum
Replies
Last Post
Shainiac
Single Turbo RX-7's
12
07-17-19 02:20 PM
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM