Gas pedal will not go to the floor
11-10-20, 10:34 AM
#1
New to the Club!
Thread Starter
Join Date: Nov 2020
Location: Hanahan, SC
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Gas pedal will not go to the floor
I have a 1984 RX7 (all original, 12A motor) that has been sitting in the garage a while. I'm currently working to get it running again. The gas pedal will not depress to the floor, there is about 2 inches of play and then a hard stop. I replaced the throttle cable and that was not the problem. I think it has something to do with the Nikki carb; it appears the throttle is stuck closed. I'm not sure about the linkage, but haven't been able to see any linkage problems. Any ideas what this could be?
I would appreciate any help with this!
I would appreciate any help with this!
Last edited by bisaman45; 11-10-20 at 10:36 AM. Reason: Add information
Thread
Thread Starter
Forum
Replies
Last Post