1st Generation Specific (1979-1985) 1979-1985 Discussion including performance modifications and technical support sections

emissions failure!!

Thread Tools
 
Search this Thread
 
Old Nov 19, 2004 | 09:47 AM
  #1  
jezek301's Avatar
Thread Starter
Full Member
Tenured Member 15 Years
 
Joined: Nov 2004
Posts: 141
Likes: 0
From: Echterdingen, Germany
Exclamation emissions failure!!

I took my 85 GSL-SE to get it inspected and because of where I live in in Virginia, an emissions test as well. It failed the emissions test because of high carbon monoxide and one other factor (HC ppm). The results were:


15 MPH 25 MPH

Limit Reading Result Limit Reading Result
HC ppm 140 780 Fail 135 675 Fail
CO % 0.79 7.09 Fail 0.83 3.44 Fail



Does anyone know what would have caused this?? A few people I know swear it is the main converter, but could it be anything else. I have 14 days to correct the problem or pay for another try after that.
Reply
Old Nov 19, 2004 | 10:56 AM
  #2  
JDGJr85GSLSE's Avatar
JDGJr
Tenured Member: 20 Years
 
Joined: Aug 2004
Posts: 141
Likes: 0
From: 7400 ft plus jack stands
Does your car backfire at all, or your exhaust smell really rich?

When I brought my new purchase up to Denver, it backfired like crazy and smelled really rich. My problem was the Air Control Valve which pumps air into the exhaust to dilute the gasses and so the cat can burn off the bad stuff. If you need one of these, try to get a used one. The new or refurbed ones are really expensive ($300 - $500).

my cats were completely trashed, and the main converter only cost about $250, new.

good luck, I was in a similar situation not able to drive cause I couldn't get past emissions.
Reply
Old Nov 19, 2004 | 09:37 PM
  #3  
jezek301's Avatar
Thread Starter
Full Member
Tenured Member 15 Years
 
Joined: Nov 2004
Posts: 141
Likes: 0
From: Echterdingen, Germany
Thanks for the tip. My car doesn't backfire and it smells a little rich but nothing too extreme. I am sure that one of those many valves is causing me these problems!
Reply
Old Nov 19, 2004 | 09:38 PM
  #4  
jezek301's Avatar
Thread Starter
Full Member
Tenured Member 15 Years
 
Joined: Nov 2004
Posts: 141
Likes: 0
From: Echterdingen, Germany
By the way, how did you fix your problem???
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
17
Jun 3, 2024 03:25 PM
HalifaxFD
Canadian Forum
126
May 9, 2016 07:06 PM
BUSTN
General Rotary Tech Support
1
Sep 21, 2015 05:01 PM
RedBaronII
3rd Generation Specific (1993-2002)
4
Sep 20, 2015 11:29 AM




All times are GMT -5. The time now is 03:27 PM.