(COOLING/OIL) Source for OMP lines
03-18-05, 03:23 PM
#1
Junior Member
Thread Starter
Join Date: Mar 2005
Location: Ohio
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
(COOLING/OIL) Source for OMP lines
Found my OMP lines are leaking on my '84 rx7. Upon calling the local Mazda dealership, they say they can no longer get the lines. Are there any aftermarket sources out there, or some other alternative to dealing with the problem? I just bought the car less than a week ago, and still trying to sort all it's quirks out. Idles rough, almost stalls when you push the accelerator from idle, noisy wheel bearing and rattling rear shock.
Thanks in advance for any info,
Thunderpup
03-18-05, 03:30 PM
#2
ok for the OMP line you can just premix your gas, there is some arguements about the amount to premix but I think its 1/4 of a quart each fill up. The stalling from idle can be several things: a vacuum leak, bad timing, bad a/f mixture, or the same problem as me a blown ignitor. Take a timing light to your plugs and make sure they are getting spark. Since you just purchased it I recommend doing a full tune up: new fuel filter, new air filter, new plugs (NGK!), wires, engine oil, tranny oil, diff fluid, new coolant... All that good stuff! Good luck, oh yes and the best advice I can give you is unless you have a local rotary shop don't take your vehicle to a shop even the mazda dealerships... You would be amazed at how little some actually know about rx7's
03-18-05, 04:16 PM
#3
Rotary Enthusiast
Join Date: Dec 2004
Location: Campbell, CA
Posts: 1,025
Likes: 0
Received 0 Likes
on
0 Posts
03-18-05, 04:31 PM
#6
Rotary Freak
Trending Topics
03-18-05, 10:02 PM
#8
Full Member
Join Date: Mar 2003
Location: Florida
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM
