Wolf 3D Wolf3d V4 Wiring guide
#1
Wolf3d V4 Wiring guide
Here is some info we all need to get our wolf3d wired up. Thanks to evilrotor and ReTed this info.
-------------------------------------------------------------------------------------------------
TPS
Brown: +5V
Green/Red : SiG
Black/Red : GND
-------------------------------------------------------------------------------------------------
Coils
IGN1 - RED Trailing Coil 1
IGN2 - YELLOW Leading Coil (1 & 2)
IGN3 - GREY Trailing Coil 2
Wolf Color ---------------- Mazda Color
RED-------------- RED Trailing Coil
GREY ----------- WHITE Trailing Coil
YELLOW ---------- RED Leading Coil
Mazda Yellow also goes to my cars TACH, since the Wolf has a simulated TACH out for its RPM display.
Coil Wiring the lazy way
(Stock Connector which used to plug into stock ECU, plug used to come from under dash into stock ECU)
pin 1V or green/yellow; leading
pin 1X or blue/yellow; trailing signal
pin 1U or brown/yellow; trailing toggle
-------------------------------------------------------------------------------------------------
Fuel Injectors
Pin 30: +12V Battery
Pin 87: +12V to Injectors
Pin 85: Ground
Pin 86: +12V Switched Ignition
-------------------------------------------------------------------------------------------------
Fuel Pump
Fuel Pump Relay doesn't use switched igniton. Pin 30 and 86 get +12V Battery, and 85 goes to Wolf FP wire, 87 goes to FP.
-------------------------------------------------------------------------------------------------
Crank angle sensor (stock)
Red and Green wires both go to pin 27
White wire goes to pin 28
White/black wire goes to pin 6
-------------------------------------------------------------------------------------------------
TPS
Brown: +5V
Green/Red : SiG
Black/Red : GND
-------------------------------------------------------------------------------------------------
Coils
IGN1 - RED Trailing Coil 1
IGN2 - YELLOW Leading Coil (1 & 2)
IGN3 - GREY Trailing Coil 2
Wolf Color ---------------- Mazda Color
RED-------------- RED Trailing Coil
GREY ----------- WHITE Trailing Coil
YELLOW ---------- RED Leading Coil
Mazda Yellow also goes to my cars TACH, since the Wolf has a simulated TACH out for its RPM display.
Coil Wiring the lazy way
(Stock Connector which used to plug into stock ECU, plug used to come from under dash into stock ECU)
pin 1V or green/yellow; leading
pin 1X or blue/yellow; trailing signal
pin 1U or brown/yellow; trailing toggle
-------------------------------------------------------------------------------------------------
Fuel Injectors
Pin 30: +12V Battery
Pin 87: +12V to Injectors
Pin 85: Ground
Pin 86: +12V Switched Ignition
-------------------------------------------------------------------------------------------------
Fuel Pump
Fuel Pump Relay doesn't use switched igniton. Pin 30 and 86 get +12V Battery, and 85 goes to Wolf FP wire, 87 goes to FP.
-------------------------------------------------------------------------------------------------
Crank angle sensor (stock)
Red and Green wires both go to pin 27
White wire goes to pin 28
White/black wire goes to pin 6
Last edited by Net Seven; 12-19-04 at 11:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM
HalifaxFD
Canadian Forum
126
05-09-16 07:06 PM