Here is some info we all need to get our wolf3d wired up. Thanks to evilrotor and ReTed this info.
-------------------------------------------------------------------------------------------------

TPS
Brown: +5V
Green/Red : SiG
Black/Red : GND
-------------------------------------------------------------------------------------------------

Coils
IGN1 - RED Trailing Coil 1
IGN2 - YELLOW Leading Coil (1 & 2)
IGN3 - GREY Trailing Coil 2

Wolf Color ---------------- Mazda Color

RED-------------- RED Trailing Coil
GREY ----------- WHITE Trailing Coil
YELLOW ---------- RED Leading Coil

Mazda Yellow also goes to my cars TACH, since the Wolf has a simulated TACH out for its RPM display.

Coil Wiring the lazy way
(Stock Connector which used to plug into stock ECU, plug used to come from under dash into stock ECU)

pin 1V or green/yellow; leading
pin 1X or blue/yellow; trailing signal
pin 1U or brown/yellow; trailing toggle
-------------------------------------------------------------------------------------------------
Fuel Injectors
Pin 30: +12V Battery
Pin 87: +12V to Injectors
Pin 85: Ground
Pin 86: +12V Switched Ignition
-------------------------------------------------------------------------------------------------

Fuel Pump
Fuel Pump Relay doesn't use switched igniton. Pin 30 and 86 get +12V Battery, and 85 goes to Wolf FP wire, 87 goes to FP.
-------------------------------------------------------------------------------------------------

Crank angle sensor (stock)
Red and Green wires both go to pin 27
White wire goes to pin 28
White/black wire goes to pin 6

 

Thanks! Now aslong as my wolf comes in tommorow.. i can use this

-Jacob

 

Any info on hooking up one for a 20b?

 

i know this is old but i love you no homo lol