Wolf3d V4 Wiring guide
Here is some info we all need to get our wolf3d wired up. Thanks to evilrotor and ReTed this info.
------------------------------------------------------------------------------------------------- TPS Brown: +5V Green/Red : SiG Black/Red : GND ------------------------------------------------------------------------------------------------- Coils IGN1 - RED Trailing Coil 1 IGN2 - YELLOW Leading Coil (1 & 2) IGN3 - GREY Trailing Coil 2 Wolf Color ---------------- Mazda Color RED-------------- RED Trailing Coil GREY ----------- WHITE Trailing Coil YELLOW ---------- RED Leading Coil Mazda Yellow also goes to my cars TACH, since the Wolf has a simulated TACH out for its RPM display. Coil Wiring the lazy way (Stock Connector which used to plug into stock ECU, plug used to come from under dash into stock ECU) pin 1V or green/yellow; leading pin 1X or blue/yellow; trailing signal pin 1U or brown/yellow; trailing toggle ------------------------------------------------------------------------------------------------- Fuel Injectors Pin 30: +12V Battery Pin 87: +12V to Injectors Pin 85: Ground Pin 86: +12V Switched Ignition ------------------------------------------------------------------------------------------------- Fuel Pump Fuel Pump Relay doesn't use switched igniton. Pin 30 and 86 get +12V Battery, and 85 goes to Wolf FP wire, 87 goes to FP. ------------------------------------------------------------------------------------------------- Crank angle sensor (stock) Red and Green wires both go to pin 27 White wire goes to pin 28 White/black wire goes to pin 6 |
Thanks! Now aslong as my wolf comes in tommorow.. i can use this :D
-Jacob |
Any info on hooking up one for a 20b?
|
i know this is old but i love you no homo lol
|
All times are GMT -5. The time now is 04:27 AM. |
© 2024 MH Sub I, LLC dba Internet Brands