coxxoc

iTrader: (3)

What are you guys seeing as a noise count when the car is running? I get up to 7 (which I think must be horrible). The trigger voltage is set to very low, which I know increases it, but the car doesn't start too well without a low setting.

Josh

coxxoc

iTrader: (3)

Additional information. It only gets up to 7 when cold and right after starting (idle). Normally it is at 1. Syncx is normally at 1 or 2.

Josh

Michael Smith

Thats normal to get a few at cranking and starting but after that it shouldn't go up at all.

Cheers
Michael Smith

CrackHeadMel

iTrader: (2)

you can set it so voltage level is low at first and ramps up over rpm or something to that effect (been to long, i forget)


howlong of a drive does it take you to get 7, i would get alot more than that with my old cas, i swapped out to one that was closer to the fsm's reccomended specs and iirc i only get 1 or 2

coxxoc

iTrader: (3)

On the dyno this weekend, it was only 0 or 1 when the car is warm. The high count is during cold starts. It seems that is normal per Michael.