Wolf 3D Need help from a Wolf expert.
#1
I am a Newbie
Thread Starter
Join Date: Mar 2006
Location: Ottawa
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Need help from a Wolf expert.
I am trying to use the Aux output in RPM mode to turn on at 3000 RPM to operate an air pump to drive my six ports. I believe I have it all configured correctly however I do not understand the functioning of the Wolf. I am told that the Wolf should send out a ground at 3000 RPM yet when I hook a relay up to it (sensitive to a ground), the relay operates immediately and when it hits 3000 RPM the relay releases. This seems backwards to me.
Can anyone shed any light on this for me?
Thanks,
John
Can anyone shed any light on this for me?
Thanks,
John
#2
Rotary Enthusiast
Join Date: Feb 2004
Location: North Queensland Australia
Posts: 778
Likes: 0
Received 0 Likes
on
0 Posts
Hi John what model Wolf do you have? (Version 3/4 Stand alone or plugin)and what pinouts are you using please?
Cheers
Michael Smith
P.S. I just pulled my port sleeves out and reported the inlet to get another 20Hp at the rear wheels.
Cheers
Michael Smith
P.S. I just pulled my port sleeves out and reported the inlet to get another 20Hp at the rear wheels.
Last edited by Michael Smith; 05-19-06 at 11:28 PM.
#3
I am a Newbie
Thread Starter
Join Date: Mar 2006
Location: Ottawa
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
Greetings Michael from the shadow of the peace tower in Ottawa where it is rainy and cool.
I am using the 3D Version 3 Standalone.
I am using Pin 5 (Red Wire) as per the attached diagram.
Sure hope you can enlighten me, many have tried unsuccessfully on other issues.
Thanks a bunch and have a great day.
John
I am using the 3D Version 3 Standalone.
I am using Pin 5 (Red Wire) as per the attached diagram.
Sure hope you can enlighten me, many have tried unsuccessfully on other issues.
Thanks a bunch and have a great day.
John
Thread
Thread Starter
Forum
Replies
Last Post