New FD engine wire harnesses with mil spec wire.
#26
Junior Member
iTrader: (2)
Join Date: Oct 2010
Location: new york
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
are you still making the harness please email me at zainool@aol.com
#27
are you still making the harness please email me at zainool@aol.com
I sent you a PM.
#28
Full Member
iTrader: (19)
Want to order harness.
I just started my single turbo conversion and I really wanted to get one of your harnesses. PM me or email me. This is my first post though I have been reading this forum for months. Not exactly sure how the PMs work so if you want my email is
jmm8904@aol.com.
jmm8904@aol.com.
#31
Rotary Freak
iTrader: (24)
Guys, you will NOT be any happier with GSR's craftsmanship on the harness. The quality of all connectors, wirings and wraps all top notch. You are basically paying for a MUCH better harness than OEM.
I would highly recommend GSR's harness as I personally got one, check out the front page for quality shots of the harness GSR constructed for me.
-AzEKnightz
I would highly recommend GSR's harness as I personally got one, check out the front page for quality shots of the harness GSR constructed for me.
-AzEKnightz
#41
Eats, Sleeps, Dreams Rotary
iTrader: (10)
Sorry to hear this. I know you took considerable time to source all of the connectors and thought you were ready to spool up on these. Did you lose interest or sell enough that you ran out of materials? Did you by chance sell your connector inventory to someone else who might be planning to pick up production on these? Just curious! Hope to see you again this year at SSXIV.
#42
Senior Member
iTrader: (1)
Join Date: Jun 2010
Location: Santa Monica
Posts: 475
Likes: 0
Received 0 Likes
on
0 Posts
I was planning on building these harnesses as well. Aekagsr was about a month ahead if me in development. Once he came out with his harness I stopped my development for production and just focused on a few for local friends. I got the ok from Aeka to take over this service so I am going to look back into this and I will post some numbers and see what interest is still here.
Thread
Thread Starter
Forum
Replies
Last Post
befarrer
Microtech
3
08-22-15 05:52 PM