Here is a small vid of my car on the dyno

 

That translates to ~318rwhp, not bad! What's your setup?

 

I have an Extend port with new housings and 3mm seals. Turbo is a T04B that still uses stock S4 housing that has been machined out to fit bigger wheel. 38mm external gate plumped into factory manifold with a ProfecB specII boost controller. ECU is a Haltech E6X. Quite happy with results as it was more than I was expecting

 

\/ \/

 

15 psi? thats not what your boost gauge was saying...

That thing crept to like 13-14 psi tops and dropped to 10psi by redline acoording to what i could make out of your boost gauge... so, in my book i would avg it to a 12 psi pull.

 

That's because that run(dash vision) was on 12psi setting on EBC. Max power run was 15psi dropping back to 13psi up top

 

Nice numbers. I bet you can get more=P

 

you can see the stock hotside choking you out around 6000rpm...

 

Yea and exhaust. Is only a 2.5" dump. It will do for now as I just want to get it out on track and with max power at ~6200 on hi boost means I wont have to rev the clappers out of it either