wheel offset with wide body, a quick question.
#1
Rotary Enthusiast
Thread Starter
wheel offset with wide body, a quick question.
if i have a wide body kit, that say, is 40mm wider than stock. can i just order my new 10.5 inch rims (rear) for a stock bodied fd , and then minus 40 mm from that offset? that would push it out right where it should be right? and i should be able to do the same for the front?
i know there are alot of offset questions, but didn't find any concerning widebody, so thanks guys.
harrison
i know there are alot of offset questions, but didn't find any concerning widebody, so thanks guys.
harrison
#2
Lurking..................
Join Date: Mar 2001
Location: PA
Posts: 2,220
Likes: 0
Received 0 Likes
on
0 Posts
My suggestion and I'm sure some people will follow. Get the widebody kit installed and then ACTUALLY BREAK OUT A MEASURING TAPE and get to measuring. If you're spending enough money to order wheels, and a nice wide set at that then actually get the wide-body kit installed, then take your measurements, re-check your measurements once or twice more, and then order wheels. This will ensure proper "look" and/or fitment.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM