Ohlins R&T - Cut Dust Covers?
#1
Full Member
Thread Starter
Ohlins R&T - Cut Dust Covers?
Hi guys,
I'll be installing Ohlins Road and Track kit on my FD. The instructions state to cut the bottom end of the dust boot 62mm. Having the dust boot installed without cutting it doesn't appear to show any issues.
Would the concern be that there is too much dust boot material if the shock is fully compressed? Seems odd to cut the nice edge off the bottom of the boot.
I'll be installing Ohlins Road and Track kit on my FD. The instructions state to cut the bottom end of the dust boot 62mm. Having the dust boot installed without cutting it doesn't appear to show any issues.
Would the concern be that there is too much dust boot material if the shock is fully compressed? Seems odd to cut the nice edge off the bottom of the boot.
#3
Rotary Enthusiast
Yes. Follow the directions. You can leave them a bit longer than they say
Thread
Thread Starter
Forum
Replies
Last Post
jetlude
Single Turbo RX-7's
10
09-03-14 09:58 AM
koukifc3s
2nd Generation Specific (1986-1992)
6
12-27-02 03:26 PM