So the fitting that goes directly between the compressor side and exhaust side leaks when I push it for a bit...Not bad...just enough to stink...It's one of those scre in fittings that doesn't have a washer.

I was told to re-teflon it..

Any other ideas...Just seems this spot gets so hot it would just burn that **** right off.

Whadda Ya Tink?

 

You can retape it but first I would remove the tape and see how it threads if it threads kinda loose you may have a fitting that is slightly off. In which case you will need the proper fitting. It has happened in the past on kits that were not sold through A-spec before. Also make sure you start the wrap about one to two threads back or it will get in the bearings and then you will have failure.

 

That's good info....Thanks.

 

teflon around the fitting and then some liquid gasket around the top of the threads and no more leak...Thanks