Single Dowpipe ?
#1
Turd Ferguson
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Sherman Oaks, California
Posts: 2,047
Likes: 0
Received 1 Like
on
1 Post
Single Dowpipe ?
Anyone know of a good single turbo dowpipe with a Vband on it? Been looking around and only found the rx7store.net one. Surely there are others? Or did you guys just have an exhaust shop fab one up?
thanks!
thanks!
#5
Senior Member
Join Date: Oct 2005
Location: Kirkland, WA
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
i have the same problem except no one around here makes decent downpipes. i swapped turbos and now my old dp will not fit! the old one i had fabricated really sucks so i wont go back to that shop. Unfortunately, pretty much everyone else within towing distance sucks worse. There is a place like 45 minutes away though that does all mandrel bent stuff. Would it be ok to drive with just my old dp on the highway for 45 minutes? What do i risk (aside from a ticket)?
#6
Rotary Enthusiast
iTrader: (3)
Join Date: Jan 2007
Location: st. louis
Posts: 1,000
Likes: 0
Received 0 Likes
on
0 Posts
do you have any tools? hell you oculd buy yourself a hacksaw if oyu dont mind it taking a while to cut through a pipe. if you have anyway of cutting metal buy yourself a few bends and piece it together. hose clamps and tape work well to hold things together. usually 2 45 bends and some strait piping do the trick. take the thing you mocked up to a welder and have them tig it. should cost much
Trending Topics
#8
Turd Ferguson
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Sherman Oaks, California
Posts: 2,047
Likes: 0
Received 1 Like
on
1 Post
I was just curious what you guys were using since I was about to panic from the new turbo to dp fitment.
Seems like someone smart would make them for the rx7 since everyone appears to just be DIY-ing it.
#10
Turd Ferguson
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Sherman Oaks, California
Posts: 2,047
Likes: 0
Received 1 Like
on
1 Post
Good to know b/c it used to sit fine until I picked up the Aspec GT3574. That turbo seems to sit a tad bit lower than the other on I had.
I think I got it sorted out but was concerned that the downpipe was the problem as the previous owner was the one that put it on the car. It actually looks homemade -- so I was starting to wonder about it.
Thanks for the input guys!
I think I got it sorted out but was concerned that the downpipe was the problem as the previous owner was the one that put it on the car. It actually looks homemade -- so I was starting to wonder about it.
Thanks for the input guys!
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM