When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I'm not an expert in turbos. I'd like to install it myself though, then I'll have it tuned.
1. This port has been manually tapped when I first received that turbo. On the new turbo, there seems to be some kind of threads in the blue circle. I'm not sure how to deal with it.
2. Is it me or the hole for the oil turbo feed is super small?
3. Am I supposed to drill 2 holes into that so I can plug in my feed line?
4. Can I rotate the turbine housing by removing these bolts?
Last edited by MuRCieLaGo; Jun 28, 2021 at 11:19 PM.
I'm not an expert in turbos. I'd like to install it myself though, then I'll have it tuned.
1. This port has been manually tapped when I first received that turbo. On the new turbo, there seems to be some kind of threads in the blue circle. I'm not sure how to deal with it. The part circled on the new one is a speed sensor mount, there should still be casting material in the bottom of the hole, don't drill it unless you are going to fit a speed sensor, the one below that with an inhex plug should be a compatible thread for a barb fitting.
2. Is it me or the hole for the oil turbo feed is super small? They are restricted, if it's about 1mm that's right, but it might be easier to have a new hose made as per the following point.
3. Am I supposed to drill 2 holes into that so I can plug in my feed line? Probably easier to get a new oil line made up.
4. Can I rotate the turbine housing by removing these bolts? *Compressor in picture be aware you can damage the compressor cover seal, probably best to take them right off and pull the front cover away from the seal before turning it.
Alright! Thank you. Questions 2, 3, 4 are now closed.
But I still do not understand the first question.
How am I supposed to plug the hose that goes to the boost controller? The threads are very small on the new one and it seems to be going nowhere.
The port you circled in your first photo is not for a boost controller. From the factory that hole should NOT go all the way through. Are you saying that it was drilled through before you received it?
It is just there in case owners want to run a turbo speed sensor, like this: https://www.full-race.com/store/borg-warner-efr/turbos-efr-series/borgwarner-efr-turbo-speed-sensor-kit-2/
If it hasn't been drilled through then you don't need to do anything.
Last edited by fendamonky; Jun 29, 2021 at 12:55 PM.
The port you circled in your first photo is not for a boost controller. From the factory that hole should NOT go all the way through. Are you saying that it was drilled through before you received it?
