hks to4e with a 50mm racing wastegate
#1
hks to4e with a 50mm racing wastegate
I just purchased a hks t04e,manifold and 50mm hks racing wastegate. My question is do I need a restrictor in the oil feed line and how do I setup my wastegate. It has 2 nipples for pressure I asume. I also have a greddy profec a boost controller. So how do I setup the wastegate with my boost controller
Thanks Robert
Thanks Robert
#2
multipersonality disorder
Join Date: Feb 2002
Location: so. cal
Posts: 5,656
Likes: 0
Received 0 Likes
on
0 Posts
bottom port to the compressor housing, top port to the boost controller.
restrictor depends on... you can probably get away without one if you use a -3 oil feed to the turbo.
restrictor depends on... you can probably get away without one if you use a -3 oil feed to the turbo.
#4
Senior Member
Join Date: Dec 2004
Location: van city
Posts: 466
Likes: 0
Received 0 Likes
on
0 Posts
get this
http://www.atpturbo.com/Merchant2/me...egory_Code=BCS
and run a -4 line
do it the right way the first time, and you wont have problems. my friend tried not using a restrictor, and burns a ton of oil because it gets past the turbo seals
cheers,Dan.
http://www.atpturbo.com/Merchant2/me...egory_Code=BCS
and run a -4 line
do it the right way the first time, and you wont have problems. my friend tried not using a restrictor, and burns a ton of oil because it gets past the turbo seals
cheers,Dan.
Thread
Thread Starter
Forum
Replies
Last Post
rx8volks
Canadian Forum
0
09-01-15 10:46 PM