hks to4e with a 50mm racing wastegate
 

I just purchased a hks t04e,manifold and 50mm hks racing wastegate. My question is do I need a restrictor in the oil feed line and how do I setup my wastegate. It has 2 nipples for pressure I asume. I also have a greddy profec a boost controller. So how do I setup the wastegate with my boost controller
Thanks Robert

bottom port to the compressor housing, top port to the boost controller.

restrictor depends on... you can probably get away without one if you use a -3 oil feed to the turbo.

Thanks Dave for the info
Rob

get this

http://www.atpturbo.com/Merchant2/me...egory_Code=BCS

and run a -4 line :)

do it the right way the first time, and you wont have problems. my friend tried not using a restrictor, and burns a ton of oil because it gets past the turbo seals :(

cheers,Dan.

hks uses garrett turbos, right? you think a .060 might be a little small for a non-bb?

They use a garrett turbo. It has a 60-1 compressor and .84 exhaust side. Thanks again for the info.
Robert