Help identifing turbo (sorry another one)
#1
Junior Member
Thread Starter
Help identifing turbo (sorry another one)
Hi,
I've had this turbo sitting around for a few years, been used as a show piece and lifting weight. I was told when I swapped it, that it was a TA45 and was from a Diesel truck engine.
I've spent many hours trying to find information but havn't found if it is actually a TA45.
So hopefully you guys may have better idea, so then I can decided if it will be any use on my setup that I'm building. S4 13B bridge port.
Compressor:
Inducer: 68mm
Exducer: 91mm
No markings on compressor housing as been grind ed off and polished
Exhaust:
Inducer: 87mm
Exducer: 77mm
Exhaust housing Tang divided T6
Has markings, Garrett DSH6A M1 A/R 1.53 and 49A94
Only markings on center cartridge 99 BSF 3 and is journal bearings is not water cooled.
Any help will be greatly appreciated.
I've had this turbo sitting around for a few years, been used as a show piece and lifting weight. I was told when I swapped it, that it was a TA45 and was from a Diesel truck engine.
I've spent many hours trying to find information but havn't found if it is actually a TA45.
So hopefully you guys may have better idea, so then I can decided if it will be any use on my setup that I'm building. S4 13B bridge port.
Compressor:
Inducer: 68mm
Exducer: 91mm
No markings on compressor housing as been grind ed off and polished
Exhaust:
Inducer: 87mm
Exducer: 77mm
Exhaust housing Tang divided T6
Has markings, Garrett DSH6A M1 A/R 1.53 and 49A94
Only markings on center cartridge 99 BSF 3 and is journal bearings is not water cooled.
Any help will be greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post