Garrett turbo oil feed fittings
#1
The wankel way!!
Thread Starter
Join Date: May 2008
Location: New Zealand
Posts: 462
Likes: 0
Received 0 Likes
on
0 Posts
Garrett turbo oil feed fittings
Its never the same is it :roll:
Ive had to replace the CHRA on my T51R after a motor failier and the new CHRA from Garrett is slightly different.
Turns out the oil feed on the old and new T51Rs are totaly different. The old one has this bolt on restrictor, and the new has the "bearing locating pin" according to the CRAP install instructions that came with it.
Im guessing this sort of oil feel needs to use a special flanged fitting that presses down on this "Pin"??
See pics to explain
Old core:
Bolt on fitting:
Inside of the fitting:
New core:
Ive had to replace the CHRA on my T51R after a motor failier and the new CHRA from Garrett is slightly different.
Turns out the oil feed on the old and new T51Rs are totaly different. The old one has this bolt on restrictor, and the new has the "bearing locating pin" according to the CRAP install instructions that came with it.
Im guessing this sort of oil feel needs to use a special flanged fitting that presses down on this "Pin"??
See pics to explain
Old core:
Bolt on fitting:
Inside of the fitting:
New core:
#2
The one
iTrader: (5)
Looks like you need this http://www.aptuning.net/Aluminum_Oil...tp-fla-008.htm
or this http://www.aptuning.net/Oil_Feed_Fla...tp-fla-020.htm
or this http://www.aptuning.net/Oil_Feed_Fla...tp-fla-020.htm
Thread
Thread Starter
Forum
Replies
Last Post
Kyo
2nd Generation Specific (1986-1992)
3
08-14-15 02:00 PM