AN fitting question
AN fitting question
I'll be running a -3 AN feed line on a to4e.
My question is what fitting/size/thread pitch do I need in order to use the stock oil feed line or to plumb directly into the block (where the banjo bolt normally goes)
I saw someone use the hard line on the s6 and i think they are identical as the s4/5.
As for the drain i'm using the stock pipe and I need a hose that can go over that. Would a -12AN be big enough to go over the outer diameter of the stock pipe (from front cover)?
My question is what fitting/size/thread pitch do I need in order to use the stock oil feed line or to plumb directly into the block (where the banjo bolt normally goes)
I saw someone use the hard line on the s6 and i think they are identical as the s4/5.
As for the drain i'm using the stock pipe and I need a hose that can go over that. Would a -12AN be big enough to go over the outer diameter of the stock pipe (from front cover)?
I won't let go
Joined: Aug 2002
Posts: 3,872
Likes: 23
From: Chi -> Maidstone
Thread
Thread Starter
Forum
Replies
Last Post
ptuttle
1st Generation Specific (1979-1985)
2
Aug 27, 2015 07:03 PM
