AN fitting question
12-29-04, 06:04 PM
#1
Tenseiga
Thread Starter
iTrader: (1)
Join Date: Apr 2003
Location: Iowa
Posts: 2,252
Likes: 0
Received 0 Likes
on
0 Posts
AN fitting question
I'll be running a -3 AN feed line on a to4e.
My question is what fitting/size/thread pitch do I need in order to use the stock oil feed line or to plumb directly into the block (where the banjo bolt normally goes)
I saw someone use the hard line on the s6 and i think they are identical as the s4/5.
As for the drain i'm using the stock pipe and I need a hose that can go over that. Would a -12AN be big enough to go over the outer diameter of the stock pipe (from front cover)?
My question is what fitting/size/thread pitch do I need in order to use the stock oil feed line or to plumb directly into the block (where the banjo bolt normally goes)
I saw someone use the hard line on the s6 and i think they are identical as the s4/5.
As for the drain i'm using the stock pipe and I need a hose that can go over that. Would a -12AN be big enough to go over the outer diameter of the stock pipe (from front cover)?
Thread
Thread Starter
Forum
Replies
Last Post