Dyno time @ PFSupercars today!!!
#26
600+rwhp club member
Thread Starter
Rich,
Yeah, if Ray or Sam can squeeze in a minute of their precious time to send it to me. I would be glad to post it up.
Ernie,
Thanks. I am hoping to see between 550-600 with full c16 and around 27-30psi. Hopefully my little GT40R that could, can get me there. If not, I may be going quite larger.
Yeah, if Ray or Sam can squeeze in a minute of their precious time to send it to me. I would be glad to post it up.
Ernie,
Thanks. I am hoping to see between 550-600 with full c16 and around 27-30psi. Hopefully my little GT40R that could, can get me there. If not, I may be going quite larger.
#28
600+rwhp club member
Thread Starter
nope, it wasn't. 6100 was where my power fell off because of the leading coil. I am trying to call PFSupercars now to get them to email me the sheet. As soon as I get it, I'll post it up for all to see. Thanks
#30
Nice Job to Ray and Dee!
Glad to see some healthy numbers.
That sheet is going allow better guessing around what you could make later on. Sounds like a really healthy port! Be interested to see at what rpm you hit 15psi at in, say, third gear. Guessing about 4400rpm for you.
Glad to see some healthy numbers.
That sheet is going allow better guessing around what you could make later on. Sounds like a really healthy port! Be interested to see at what rpm you hit 15psi at in, say, third gear. Guessing about 4400rpm for you.
#31
600+rwhp club member
Thread Starter
Originally Posted by Asleep
Nice Job to Ray and Dee!
Glad to see some healthy numbers.
That sheet is going allow better guessing around what you could make later on. Sounds like a really healthy port! Be interested to see at what rpm you hit 15psi at in, say, third gear. Guessing about 4400rpm for you.
Glad to see some healthy numbers.
That sheet is going allow better guessing around what you could make later on. Sounds like a really healthy port! Be interested to see at what rpm you hit 15psi at in, say, third gear. Guessing about 4400rpm for you.
Thread
Thread Starter
Forum
Replies
Last Post
stickmantijuana
Engine Management Forum
11
11-09-15 01:15 PM