dual mvr or dual mvs for gt4088r?
#1
Full Member
Thread Starter
iTrader: (2)
Join Date: Feb 2009
Location: Ontario
Posts: 222
Likes: 0
Received 0 Likes
on
0 Posts
dual mvr or dual mvs for gt4088r?
I am near the end of my build and im looking for an opinion on what gates to use with a gt4088r I will be running 2 gates and dump tubes
Compressor:
-Housing A/R: .72
-4" inlet
Turbine:
-Housing A/R: .95
-T4 w/ 3" v-band
Divided
Compressor:
-Housing A/R: .72
-4" inlet
Turbine:
-Housing A/R: .95
-T4 w/ 3" v-band
Divided
#3
Just in time to die
iTrader: (1)
The MV-S isn't a bad WG initially they had failures with them in motorsports environments and then made them water cooled. If reliability on the track is of concern either water cool them or step up to the MV-R as well. You can see dual 38's have almost as much area as a 60mm gate.
Difference in WG area is as follows.
38mm WG 1134mm dual 2268mm
44mm WG 1520mm dual 3040mm
46mm WG 1661mm dual 3323mm
50mm WG 1963mm dual 3926mm
60mm WG 2827mm dual 5654mm
66mm WG 3421mm
Hope that helps.
Difference in WG area is as follows.
38mm WG 1134mm dual 2268mm
44mm WG 1520mm dual 3040mm
46mm WG 1661mm dual 3323mm
50mm WG 1963mm dual 3926mm
60mm WG 2827mm dual 5654mm
66mm WG 3421mm
Hope that helps.
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM