I am seeking assistance from someone who has experimented or even attempted to turbocharge a P-Port. The idea has crossed my mind several times but, I have never built up the courage to experiment with my car. I have finally built up enough courage to just bite the bullet and build a "sick ***" rotary powerplant. There are some Pro Drag Race cars that have accomplished this with 3 Rotor engines, but I have yet to see a 2 Rotor project unveiled.

Thanks
Albert Mets

 

The guys at www.evil7.com do them all the time. Check out their pics.

 

I have a friend out of Philly PA that used a Mazda Factory Racing P-Port and turbo charged it. According to him, made 700flywheel HP @ 16lbs of boost. This was done at Roger Mandeville's Dyno in North Carolina. My friends name out of PA. is Joe Perez, he is a great rotary engine builder(more then 20 years of experience) the p-port engine was on a second gen. Rx7 full chassis. Joe Perez crashed this FC. But before he did, the FC ran 8.12@162mph @ low boost ..inbetween 16 to 23psi of boost.

 

i have met Joe. i have talked to him a few times at atco. he is there a lot. the man does know his ****!!

 

where is he now though? i think he moved his shop?? i forget where the old one was now that i think of it. was it/is it on 6th and dimond? or 5th and dolphin or something???

 

I think this car is a periphral port turbo
http://a-ds.serveftp.net/a-rf/video/020.wmv

Here is an N/A FD with peripheral port
http://a-ds.serveftp.net/dp-pro/SwirlSilencer_Test.wmv

The n/a FD on the streets of Japan..
http://a-ds.serveftp.net/a-rf/video/023.wmv


Max

 

Note the tach in the final one. (i got the link from dr0x over in the chat section a while back... killer vid!)

He does a lot of cruising at around 3k and he upshifts at 8k.

 

great vids

 

Timmy... nice vids

ARF Factory is in third vid. How do you know its NA?

 

Well it says "NA" in the vid...

 

If you've been around rotaries, you can tell that its a NA by the way it sounds!