Steve Kan Tuning Session, December 12th.
#278
Original Gangster/Rotary!
iTrader: (213)
I'll have to go check out some of those videos, if Steve got an 11.7 out of Pap's car then the rest of us would run mid 12s
#279
All Hail the Magic Conch!
iTrader: (5)
lets clear this up the first time wasnt franks fault. car overheated on the dyno, coolant seals gone stock ports. 2nd time, street port 60-1 new everything 2k break in. put it on the dyno left me way to lean @ 18psi oops I mean 15psi and blew the rears. as goodfella stated. and overlooked the damage to the turbo since it looked like the seals stayed inside (rookie mistake on my part), the turbine looked good with the housing on so firgured no damage, boy was I wrong. smoking over the years got progressively worse until I opened her up and...
#281
Eats, Sleeps, Dreams Rotary
iTrader: (19)
plus he is a man on a mission.......his mission is to be able to boost his car and he cannot boost until he reaches the 2000 mile mark on the new motor
yeah i told steve that i left the coupler loose on purpose so that he would run a slower time.....that way when i take the car to the track i can beat his time and prove that i am a better driver than him
#285
Full Member
Join Date: Dec 2002
Location: DMS Racing
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
ok hello every one ,,,,,,well i need to get the dyno sheets for farly ..ken's Black Fd did 385HP at 14.5psi which did very well ......Ed's Red FD 350HP 6000RPM 12psi which it had fuel problems and can't push for more power no fuel =(....... my silver FD did 565HP @6800RPM 19psi i wanted to go up to 25psi but my spark plugs which i never change (BAD LUIS !!) could not pass 7000RPM because it was braking up.... i will scan the dyno sheets soon
#286
Committee Member #3
iTrader: (7)
ok hello every one ,,,,,,well i need to get the dyno sheets for farly ..ken's Black Fd did 385HP at 14.5psi which did very well ......Ed's Red FD 350HP 6000RPM 12psi which it had fuel problems and can't push for more power no fuel =(....... my silver FD did 565HP @6800RPM 19psi i wanted to go up to 25psi but my spark plugs which i never change (BAD LUIS !!) could not pass 7000RPM because it was braking up.... i will scan the dyno sheets soon
#287
Eats, Sleeps, Dreams Rotary
iTrader: (19)
you and me both i will have to make that one of my new years resolutions....... congrats on the numbers Luis...wish i could have stuck around to watch it!!!! tell ed that if he does not want any more fuel problems to be like his little brother and buy my dual pump holder
https://www.rx7club.com/se-sale-wanted-classifieds-180/cj-motorsports-turblown-shine-nud-guards-879050/
shamless plug on my part but i figure if you guys buy my parts i can get some money to start the Corn conversion!!!!!
https://www.rx7club.com/se-sale-wanted-classifieds-180/cj-motorsports-turblown-shine-nud-guards-879050/
shamless plug on my part but i figure if you guys buy my parts i can get some money to start the Corn conversion!!!!!
Thread
Thread Starter
Forum
Replies
Last Post
demetlaw
3rd Generation Specific (1993-2002)
6
10-02-15 06:22 PM