I run a LT-8S in my 1st gen and it was tuned by Alex lopez. It runs great and put down 440Hp at 15lbs on his dyno ...NO issues since he tuned it for me..runs better than ever when it has good axles in it...
L8R

 

TWICE???? ok

 

shitty tune=>detonation=>broken apex seals=>damaged turbine wheel

I'll have to go check out some of those videos, if Steve got an 11.7 out of Pap's car then the rest of us would run mid 12s

 

lets clear this up the first time wasnt franks fault. car overheated on the dyno, coolant seals gone stock ports. 2nd time, street port 60-1 new everything 2k break in. put it on the dyno left me way to lean @ 18psi oops I mean 15psi and blew the rears. as goodfella stated. and overlooked the damage to the turbo since it looked like the seals stayed inside (rookie mistake on my part), the turbine looked good with the housing on so firgured no damage, boy was I wrong. smoking over the years got progressively worse until I opened her up and...

 

My car is in the mid 12's for sure, i ran a 12.7 before the tune and the car pulls stronger now...

 

plus he is a man on a mission.......his mission is to be able to boost his car and he cannot boost until he reaches the 2000 mile mark on the new motor

yeah i told steve that i left the coupler loose on purpose so that he would run a slower time.....that way when i take the car to the track i can beat his time and prove that i am a better driver than him

 

That's pretty bad-***, i would love to have a dyno like that in my garage so i can have fun with it on weekends lmao...

 

yea, dont have to wait in line to go again

 

.

 

ok hello every one ,,,,,,well i need to get the dyno sheets for farly ..ken's Black Fd did 385HP at 14.5psi which did very well ......Ed's Red FD 350HP 6000RPM 12psi which it had fuel problems and can't push for more power no fuel =(....... my silver FD did 565HP @6800RPM 19psi i wanted to go up to 25psi but my spark plugs which i never change (BAD LUIS !!) could not pass 7000RPM because it was braking up.... i will scan the dyno sheets soon

 

I think its time for me to switch over to that CORN Juice!!!

 

you and me both i will have to make that one of my new years resolutions....... congrats on the numbers Luis...wish i could have stuck around to watch it!!!! tell ed that if he does not want any more fuel problems to be like his little brother and buy my dual pump holder

https://www.rx7club.com/se-sale-wanted-classifieds-180/cj-motorsports-turblown-shine-nud-guards-879050/

shamless plug on my part but i figure if you guys buy my parts i can get some money to start the Corn conversion!!!!!

 

lol its all about that E85 $2.21 per Gal......

 

Nice numbers luis
What dyno were you using?

 

It was on a Dyno Dynamics Dynometer as posted by Steve in another thread...

L8R