Stock chassis FB Street Machine
#78
Looking for clutch and pressure plate options for this setup. I am planning on running the RAM sintered iron clutch setup for the Jerico 4 speed *clutch assisted. But am not sure what pressure plate. I was thinking of using the stage 2 Exedy pressure plate for this.
All of it housed inside this device right here...
Bellhousing - Mazda RX-7 13B/20B to Muncie/Jerico Transmissions - Bellhousings - Drivetrain
Thanks for looking.
All of it housed inside this device right here...
Bellhousing - Mazda RX-7 13B/20B to Muncie/Jerico Transmissions - Bellhousings - Drivetrain
Thanks for looking.
#80
Do you any pictures of the rear control arms. , your set up looks like a real stock chassis. , looking real good , no sabia que eras Hispano lei el post en grs. ,
What a big difference from your Blowthru. Set up. Looks like u went all out on the. Fuel injection set up. , hope u put down some good numbers
What a big difference from your Blowthru. Set up. Looks like u went all out on the. Fuel injection set up. , hope u put down some good numbers
#81
For the rear control arms I built my own lowers using 5/8" beim joints with stock uppers with polyurethane bushings. I still have a watts link, stock GSLSE springs with Cometition Engineering 60/40 shocks.
¡Representando lo nuestro siempre!
Now I just need to get hot with the new bellhousing and 7.50 roll cage, it is in fact a complete, uncut stock chassis. It is going to hurt me to have to cut the transmission tunnel to install the Jerico 4 speed!
¡Representando lo nuestro siempre!
Now I just need to get hot with the new bellhousing and 7.50 roll cage, it is in fact a complete, uncut stock chassis. It is going to hurt me to have to cut the transmission tunnel to install the Jerico 4 speed!
Thread
Thread Starter
Forum
Replies
Last Post
Claudio RX-7
Haltech Forum
5
04-23-19 02:50 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM
Turblown
Vendor Classifieds
0
08-18-15 10:01 PM