allright guys
down to reall tranny
am mounting a g101 4 speed with the fd bell housing and starter
the only problem is that the slave cylinder is in the way so I have to eliminate it from pul type
I was thinking of getting the turbo 2 clutch and install a hydraulic trow out bearing any body using one one
thats all I need
also any body knows about the rear diff like the torque arm granny speed shop sells
or any body using someting else to hold that diff in place when not using PPF

 

call ari at rx7.com, he has a similar set up in his car, he can help you out

 

Here's the deal.
You just can't switch between those bellhousings. The FD was designed for a longer input shaft. Honestly most of the G-force trannies are set up for the TII or the RX-3/4 bellhousings.
Varify which bellhousing your tranny was set up for.

 

that's the deal

 

For the hour!

 

hey cris thanks for that info
i was try to call you yesterday on that phoone # you once gave, no luck

I think i will giving ari a call today

 

okay guys small update
tranny is in and running
am using the 93+ bell housing with starter and a hydraulic release bearing
I had to kind of modify my own PPF
thats about it
I also had to cut the tunel a bit for the shifter to work

I did some passes this weekend but no 9s yet
I cant seem too launch to get a good 60ft like 1.5 or 1.4s
also first time using the line lock, on one pass, i did not let it go on time
but the tranny shifts sweet
I cant wait to rent out the track or get more seat time

today i might check on my pinion angle and see if its all okay
also probally go to the dyno again and lower some boost, before the next time out

 

Thats the same tranny I ordered. Actually Ari ordered it for me with the turboII adapter plate. Mine will be clutch assisted though and h pattern. What gear ratios did you go with?

 

1 st 3.483
2nd 2.05
3rd 1.391
4th 1

 

3.483 !!!!!!!!!!!!!

 

I went with a bit longer first. 3.48 is pretty short.

 

What first did you go with Ernie?

 

Ari picked them for me. If I recall correctly a 3.20

 

What is your rear axle ratio? your running a 26" tire correct?

 

4.10's and 26"

 

How high are you revving?

 

oops
sorry guys what i posted was the stock mazda tranny #
in the g101 is
3.207
2.059
1.359
1.00


mike long from g-force said should work fine with the 4.10
and yes am running the 26 x 10.5 15 inch wheel

ernie I just wanna let you know, this is the best you have done

the clutchless shifts smooth, and the car drives like a cadillac
I just cant wait to get a good 60ft

 

8500ish..