Engine's dead, I'm going full bridge..

 

if you have 3mm apex seals you can use the 74-79? ones
1011-11-321, if you are keeping the 2mm seals i dunno

mike

 

2 or 3 mm is here

http://www.mazdacomp.com/

 

how much boost you want to pull? solid corner seal will shorten the life of the motor even more!

 

I could run stock corner seals, but I've heard horror stories of the rubber piece droping in to the bridge and getting sucked back in to the engine...

 

Then don't use the rubber piece!
I won't even use the rubber piece with a good street port!

crispeed
87TII
9.20@150mph 1/4
5.90@120mph 1/8
1.31 60ft
650RWHP/520RWTQ
T-72
2600lbs

 

Have you ever had any problems running the stock corner seal w/out the rubber peice?

 

I've never used the rubber piece in any of my engines, no problems yet after 100K combined engine miles.

 

Thnaks for the info...

Chris

 

back from the dead...

What are opinions on using atkins solid 2mm corner seal or FD corner seals without the rubber piece?

My engine is almost ready to be re-assembled and I'm not sure which seal to use

thanks

 

bump

anyone?

 

omg a 3 year bump... should have just made a new thread