have ne1 had problems with atkins seals.

Reply Subscribe

Thread Tools

Search this Thread

Dec 20, 2006 | 10:03 AM

#26

ErnieT

Living life 9 seconds at a time

iTrader: (2)

Joined: Feb 2001

Posts: 6,541

Likes: 0

From: Abingdon, Md

Im using the Adkins cryoed apex seals, so far so good!

Dec 22, 2006 | 12:22 AM

#27

Boostn7

Rotary Enthusiast

Joined: Feb 2001

Posts: 867

Likes: 0

From: Union, NJ

Quote:

Originally Posted by Atkins Dan

Boostn7 Did you have thoes castirons relapped before the last rebuild?????

Dan

No, those irons originally came to me for porting and were all within spec with no sign of wear on top or bottom.

FYI: FD corner seal springs used.

JD

Dec 22, 2006 | 12:40 AM

#28

Boostn7

Rotary Enthusiast

Joined: Feb 2001

Posts: 867

Likes: 0

From: Union, NJ

Quote:

Originally Posted by ErnieT

Im using the Adkins cryoed apex seals, so far so good!

Mazda or Atkin's corners?

Why Atkins cryoed treated seals over ceramics or any other expensive seal ?

JD

Dec 26, 2006 | 08:48 PM

#29

peejay

Old [Sch|F]ool

Joined: May 2001

Posts: 12,865

Likes: 571

From: Cleveland, Ohio, USA

Quote:

Originally Posted by rx7vadim

how is that pp motor running peejay

It's not, it's been sitting in boxes since last October-ish. I need EFI or a decent carb or something.

That's why I have to rev the wotsis out of my engine to make any power, stupid inefficient sideports. When the P-port goes back in, the 3.91s will probably go back in too.