e11 running nitrous question
#1
GRINCHY
Thread Starter
Join Date: Dec 2005
Location: oz
Posts: 182
Likes: 0
Received 0 Likes
on
0 Posts
e11 running nitrous question
My e11 won't activate the relay to run my nitrous. I have it in normal mode
acting as a ground. I fiddled with all the parameters so it would activate
under light throttle just to test the solenoids. When I reverse it to inverted
and 12 volts, it activates constantly- sending 12v constantly.
Worse case scenario, i'll run a window switch and wide open throttle
switch externally. Anyone seen this before? btw I'm using pmw #1
acting as a ground. I fiddled with all the parameters so it would activate
under light throttle just to test the solenoids. When I reverse it to inverted
and 12 volts, it activates constantly- sending 12v constantly.
Worse case scenario, i'll run a window switch and wide open throttle
switch externally. Anyone seen this before? btw I'm using pmw #1
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM