My e11 won't activate the relay to run my nitrous. I have it in normal mode
acting as a ground. I fiddled with all the parameters so it would activate
under light throttle just to test the solenoids. When I reverse it to inverted
and 12 volts, it activates constantly- sending 12v constantly.
Worse case scenario, i'll run a window switch and wide open throttle
switch externally. Anyone seen this before? btw I'm using pmw #1

 

Did you set up an AUX in to let the ecu know that the Nitrous system is armed?
You should post this in the ecu forums.

 

ok, will try- thanks