I want to make a quad injector setup on my UIM and I'm looking for sockets to house the injectors (aluminium and weldable)

Is there anyone offering these?

 

MSD offers them, although I would imagine shipping and duty would make them quite expensive.

I made my own. They're trivial to make.

 

http://tinyurl.com/ygn2v3q

Sorry, I couldn't resist... here's a couple from the results:
http://www.cartech.net/fuelsystems.htm
http://www.electromotive-inc.com/efi_parts.html
http://www.rx7.com/store/rx7/fdfuel.html
http://www.kinsler.com/Cat_32_Pgs/Ca..._09_Pg_161.pdf

 

@ peejay, do you happen to have a technical drawing of yours?

gkm..... seriously man... I did search but people on specialized forums always tend to know a bit more...

 

I used square lower injector O-rings like Mazda used at least until 1988. They only require a flat surface to press against.

Since my manifold was steel, I just used a pair of tube nuts (for 5/16" fuel line) that I drilled slightly oversize for injector clearance. If I was to make an aluminum manifold, I would have just used aluminum spacers from the hardware store, or maybe just cut two "bungs" from a junk alternator.