Hi i've just put a rx6 singel turbo into my car, also upgraded fuel, exaust and ic. When I was finished installing all the parts and tried to start it all i got was a constant high piched whine. The engien turned over but would not start. Also the exaust warning light was on. As i understand it this means that some sensor is broken. But how do i figure out which one it is? Any feedback would be apresiated.

 

Check everthing affected by your single turbo instal, all wiring and hoses.l

 

I have gone over everything several times. All the hoses are on, vacuume hoses are conected corectly, And i think i have all the correct wires hooked up, but not 100% sure. What would need to be conected to make the car start?

 

are you getting fuel / checked for spark and checked all fuses?

 

Im getting fuel, found a broken fuse, going to replace it, going to check for spark eventhough its a pain in the *** any other good advice ?

 

in your commander check wich sensor isnt working check page 35 on your power fc manual if you are not sure witch sensor is not on.

 

if you dont have the english manual you can download it here.

http://www.apexi-usa.com/pdfInstallation/12.pdf

 

have looked at it already, but since i've gone over to a single setup i thought that several of the sensors could be disconected. Therefore i would like a list of which sensors i have to have and then check with the PFC and see if these are working

 

Found the problem No water in radiator=mad water temp sensor=mad car