I just received my Power FC from Japan, and low and behold, the instructions are japanese (big surprise). I ordered the new comp because I put 1600cc injectors in the car. For some reason, I cannot set the the injector size bigger than 1500cc with the commander. I have not actually run the car car yet, as it is snowing heavily and I am still waiting for my fuel pressure regulator. My question is : Can you set the injector size to 1600cc using the commander, or do you need the datalogit software to do it?

 

This is the wrong section. Where is highland in New York?

 

you need the datalogit software to do it!

 

I believe you need the datalogit for 1600's. The commander will not let you go that high.

 

a) Highland is by poughkeespsie, about 6 miles away, why do you ask? b) Sorry for posting this in the wrong section, I just figured since I had a 3rd gen it was the correct spot c) Thanks for the info.

 

the cost on the datalogit&pcf??

 

cost of the datalogit and software is 339 for a serial port connection to your laptop. The PFC price varies depending on the dealer, anywhere from 1100 to 1250 new from a seller. 850 from some guys in Japan.

www.rx7.com has both

Tim

 

Not only do you need the datalogit, but you will need the correct resistors for those injectors -- otherwise you may blow out the ignition drivers in the PFC.

 

So is this needed for the 1600 secondaries that Gothemracing sells too?(KG rail)

 

Thanks for the info. From what Keith at kgparts says, the correct resistors are 10 ohm 10 watt resistors.