If anyone can please help me out here.

Car is an s4 TII with s5 engine. I just installed a PFC using the banzai harness using their installation instructions. The car wont start.

I have fuel pressure at the primary rail,
12v at the primary injectors w ign on.
spark at the leading plugs
installed new plugs.

I re-initialized the pfc correctly
set injectors to 550cc for secondaries (I still have stock TII injectors)
turned off o2 f/b
selected PIM option 2 (for GM 3-bar map sensor)
tps is good.

Car ran fine before removing the stock ECU
I have also tried another known working pfc with no luck.

Anyone have any ideas

 

Re-initializing the PFC resets it to the default map, which does not contain the setting on option 2 for the GM 3 bar map sensor.