I just installed my PFC, along with many other mods (single turbo, front mount, bigger radiator, etc.). Upon install I turned on my car to make sure everything was working right. It seems to be running ok except that it is idling at 2k rpm. I'm going to try adjusting the idle bleed screw and hopefully that works.
Second, my car starting running warm (don't have the radiator fan back on yet) and the coolant warning light came on. Is that prob. the only reason it was beeping at me or does the PFC use this to communicate (read that somewhere). any advice is greatly apreciated.

Brian

 

Adjust the bleed screw, that should bring the idle down.
You may need to burp the system to get all the air out. Your warning light should not come on.

Jason

 

The 4 wires cut?

Remember the PFC will go through a learn mode for about 20 minutes the first time you install it.

Put the fans back on. Beeper is bad. You don't want to toast a water seal after all that work!