I disconnected the fuel temperature sensor. The PFC but shows great value. ECU is dependent on that signal? it is sufficient to just disconnect
I finished repairing the engine (new apex seals etc.) and before that I do not look to PFC.

 

No problem as that is normal "error" value for a missing sensor.
If you have a DL, go to screen Settings 2, INJ vs Fuel Temp, change 1.020 setting to 1.000.

This is what all of us using non stock secondary fuel rails do.

 

If you unplug the fuel temp it will max out the voltage, same thing will happen if you unplug your map sensor

Your TPS settings are too low (vta1, vta2)

 

Dear cewrx7r1, i will change with DT settings 2, like you send. Thanks.

By the way Banzai-Racing, in manual is
VTA1: closed 0,10 to 0,70 open 4,2 to 4,6
VTA2: closed 0,75 to 1,25 open 4,8 to 5,0
I´m in tolerance, what are yours recommended values.

Thank you