could someone please direct me toward or provide me with a fuel map and whatever else i might need to change with my Power FC for the following mods: downpipe, hi-flow cat, catback, intake. I would have thought that with these mods benig so common these maps would be easier to find, but everywhere i look i find broken links or maps that don't fit what i need. thanks in advance.

-neeraj

 

The latest PFC version 5.08 is already setup for what you have.

 

yes thank you, i'll check to see what version mine is in a few minutes.

 

yes i have the 5.08, so this means i'm fine then?

 

yep, you're fine. How much boost do you plan on running?

 

whatever's safe, i don't have a boost controller =\

 

the commander can control boost...keep it at 10 psi since u have a stock ic still. read the manual on how to control boost.

 

the base maps do come for fuel programmed t 16psi right? (in case of spikes or creep?)

 

Hi, would that mean for Yayer's setup, if he adds a big IC and ups boost he can stick with the base map?

Just that I am in a similar situation.

I have Intake, DP, mid pipe so far. And have so far seen that the PFC will be ok with its base map at 10psi.

It looks like I should get my FMIC before raising boost, but I wanted to know if I will have to modify the map for this?

Or do I have to get a Datalogit and wideband at the same time as adding the IC?

Thanks

Trevor

 

I have intake, FMIC, DP, High flow cat, Catback And my car was DANGEROUSLY LEAN on the top end, at only 12 psi.

Be very careful running the base maps. I was told that they were plenty safe and tuned very rich but my car was seeing 12.5-12.8 afr. Luckily I got it tuned before any damage was done.