Question

I have a Autometer Sport Comp digital wideband w/both +/- datalogger outputs.
Also, my AEM AI has a datalogger output as well.

My question, although I think it may be a stupid one, is can I connect the + datalogger from the wideband & datalogger from AI to the 0-5v inputs on FC-Datalogit?

Thanks in advance...

 

You are correct you can hook up those outputs to the datalogit. I would recommend using the differntail input to subtract out any floating ground to give you a more accurate reading. the link below there is a brief discussion on how to set up.

https://www.rx7club.com/showthread.p...ight=datalogit

 

Ok, just to clarify...

For example, my Autometer Sport Comp II wide band has a datalogger + signal output & a optional data logger signal ground. Do I hook both up to the datalogit?

Also, my AEM AUX INJECTION controller has a 0-5v pressure out.

So, can I hook wideband datalogger output to AN1 & AEM AUX INJ. output to AN2 ?

Who knows?????

 

Hook up as follows:

AN1 : wideband +
AN2 : optional signal ground
AN3 : aux inj 0-5V pressure out

in the config screen check the box next to delta AN1-AN2

 

Thanks man, I just wanted someone to confirm it just like you did. I am gonna play w/it more this weekend.

Thanks again

 

no problem... You will also want to change the scaling so the numbers in the logger make sense. The settings should be in manuals somewhere.