Power FC 0-5V source
#2
RX-7 Bad Ass
iTrader: (55)
Probably easier is to tap into the stock MAP sensor's output - it's a 5v output. Or, get an aftermarket boost sensor, like the GM 3 bar - also 5v out.
Dale
Dale
#3
sdrawkcab
iTrader: (1)
This has been working for me for some time now, and it doesnt have to feed off the MAP, which i am a bit tentative about using.
https://www.rx7club.com/power-fc-forum-47/5-volt-supply-voltage-extra-datalogit-inputs-423894/
https://www.rx7club.com/power-fc-forum-47/5-volt-supply-voltage-extra-datalogit-inputs-423894/
#6
Originally Posted by sdminus
Where did you end up getting the sensors from.
Scott
Scott
Tony
#7
sdrawkcab
iTrader: (1)
The sensors I have were purchased from an ebay seller named pyrojoe IIRC.
If you search on the innovative WB forum you will find details on the sensor and links.
I love these sensors, and use them for a myriad of different applications, I am even using one right now to test pump performance on a seadoo, very versatile and durable.
I wish I could get a hold of different variants on the design I really could use a 150 Psig sensor.
If you search on the innovative WB forum you will find details on the sensor and links.
I love these sensors, and use them for a myriad of different applications, I am even using one right now to test pump performance on a seadoo, very versatile and durable.
I wish I could get a hold of different variants on the design I really could use a 150 Psig sensor.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
PinkRacer
2nd Generation Specific (1986-1992)
43
10-01-15 09:13 AM
stickmantijuana
20B Forum
9
09-22-15 07:39 PM