Rx2 sedan 12a turbo project
#128
Damn I should have drove it normal lol.i probably would have gone to sevenstock in it.
No worries.im done porting the center iron and will do the rest in the coming week.parts have been ordered already!
Just doing a streetport.but if it was fast as it was with stock ports I only imagine how its gonna be now
No worries.im done porting the center iron and will do the rest in the coming week.parts have been ordered already!
Just doing a streetport.but if it was fast as it was with stock ports I only imagine how its gonna be now
#129
I ended up doing a streetport,and decided to use my mint set of 74 rotor housings.
Engine is almost ready to drop in just need to find a damn 83-85 12a flywheel to match the rotating assembly.
New apex seals
New side seal springs
New side seals
New corner seal springs
New corner seals
New oil control ring springs
All new soft seals
Oh and set my wastegate with a 8lb spring
This is how it sits in my garage on the engine stand
Engine is almost ready to drop in just need to find a damn 83-85 12a flywheel to match the rotating assembly.
New apex seals
New side seal springs
New side seals
New corner seal springs
New corner seals
New oil control ring springs
All new soft seals
Oh and set my wastegate with a 8lb spring
This is how it sits in my garage on the engine stand
#131
New motor is in trying to put miles into it.it has about 100 miles into it now with no issues at all.I put new idler arm bushings cause damn they were fucked.redid the front seats,put some epsilon mesh wheels on it 15x8.5 rear and 15x7 up front.i have spare outer lips to make the rears 9" but would need to roll the fender lip,but for now it will stay like this.
Thread
Thread Starter
Forum
Replies
Last Post